Wheel hub, pressing in
WARNING: This page is about a different variant/trim than selected.
- Center assembly with clip E-76-2.
- Position wheel hub on wheel bearing.
- Position thrust piece - 1 - on back of wheel bearing housing.
- Install piston cylinder - 2 - with bolt - 3 - , special tool - 4 - and thrust piece - 5 -.
1 - Press piece E-5
2 - Piston cylinder HKZ-15
3 - Removal rods E-0-217
4 - Special nut E-8-214
- Build-up pressure with foot pump.
- Now check that all tools are correctly centered.
- Press wheel hub on by pumping foot pump.
The shoulder - arrow - of the thrust piece E-5 must face toward the special nut - 4 -.