Hub, pressing out

WARNING: This page is about a different variant/trim than selected.

Fig 1: Thrust Disc Installed

Courtesy of VOLKSWAGEN UNITED STATES, INC.

1 - Thrust disc E-39 ; Position the thrust disc so that it lies completely on the bolt heads - 2 -.

Fig 2: Piston Cylinder Hkz-15 With Hydraulic Press Piece E-0-204-T And 2 - Centering With Clip E-76-2

Courtesy of VOLKSWAGEN UNITED STATES, INC.

1 - Piston cylinder HKZ-15 with hydraulic press piece E-0-204-T

2 - Centering with clip E-76-2

NOTE:

Place engine/transmission jack V.A.G 1383/A , or similar, underneath to ensure safety (danger of accident through falling parts when pressing out the wheel hub).

Fig 3: Support , Piston Cylinder With Pull Rod And Special Nut

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Install support - 1 - , piston cylinder - 2 - with pull rod - 3 - and special nut - 4 -.

1 - Bell E-40

2 - Piston cylinder HKZ-15

3 - Removal rods E-0-217

4 - Special nut E-8-214

5 - High pressure hose with quick release coupling

6 - Thrust pad E-39