Rear drive shafts, removing and installing: Removing
WARNING: This page is about a different variant/trim than selected.
Left and right drive shaft
- Lift vehicle until the load on the rear axle is relieved.
The wheel should still be touching the floor.
- Loosen 12-point nut.
- Disconnect drive shaft - 1 - from final drive flange shaft - 2 -.
Left drive shaft
- Push exhaust system to side with a lever
- Take drive shaft inner joint off final drive.
1 - Exhaust system
2 - Driveshaft
The continuation of the work sequence is now valid for both sides
- Press out drive shaft.
NOTE:
- When pressing axle shaft out ensure sufficient clearance is available.
- Remove drive shaft.