Right spring, removing

WARNING: This page is about a different variant/trim than selected.

Fig 1: Spring Holder V.A.G 1752/15 R. U. Installed To Spring Compressor V.A.G 1752/1

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Fig 2: Spring Holder V.A.G 1752/15 R. O. Set On The Highest Spring Coil

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Fig 3: Spring Compressor V.A.G 1752/1 And Spring Holder V.A.G 1752/15 R. U.

Courtesy of VOLKSWAGEN UNITED STATES, INC.

1 - Spring Compressor V.A.G 1752/1

2 - Spring holder V.A.G 1752/15 R. U.

Fig 4: Spring Compressor And Spring Holder Interlock Claws And Spring Holder Bolt

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Turn the spindle of the spring compressor in a clockwise direction so far, until the claws - arrows - of spring compressor and spring holder interlock.
Install bolt - 1 - at the top of spring holder.

The bolt - 1 - must be put in from the bottom.

Turn the spindle of the spring compressor until the spring is slightly tightened.
Check whether the spring holders rest correctly against the spring coils.

Fig 5: Compressing Coil Spring Until It Can Be Removed

Courtesy of VOLKSWAGEN UNITED STATES, INC.

1 - Spring holder V.A.G 1752/15 R. O.

2 - Spring Compressor V.A.G 1752/1

3 - Spring holder V.A.G 1752/15 R. U.

If a shim is under the stop buffer, you must take this out together with the spring.