Left spring, removing
WARNING: This page is about a different variant/trim than selected.
- Remove coupling rod from Left Rear Level Control System Sensor G76 from rear axle → Left Rear Level Control System Sensor G76 on the rear axle for four wheel drive .
- Place Engine-/Gearbox Jack VAG1383A under wheel bearing housing and pre-load lightly.
- Unscrew lower bolt - arrow - from shock absorbers.
- Now lower wheel bearing housing.
- Insert Spring Compressor V.A.G 1752/1 - 1 - with Spring Holder For A4 V.A.G 1752/7 - 2 -.
- Turn the spindle of the spring compressor until the spring is slightly tightened.
- Check whether the spring holders rest correctly against the spring coils.
- Compress coil spring until the spring coils touch each other (to stop).
- Take the spring with the spring compressor from the vehicle.
- Placing spring with spring compressor.