Wheel bearing, pulling out

WARNING: This page is about a different variant/trim than selected.

Fig 1: Pulling Out Wheel Bearing

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Install press piece - 1 - with shoulder to bearing, press sleeve - 2 - with four stepped internal diameters to wheel bearing housing, piston cylinder - 3 - with pull rod and special nut - 4 -.
Operate pump and remove the wheel bearing.

1 - Press piece E-5

2 - Press sleeve E-65-1

3 - Piston cylinder HKZ-15

4 - Special nut E-8-214 and pull rod