Removing Right Flange Shaft

WARNING: This page is about a different variant/trim than selected.

Fig 1: Identifying Noise Insulation Tray & Bolts

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Remove noise insulation tray.
Turn steering to right to full lock.
Remove drive axle from flange shaft.
Raise right drive axle and secure.
Remove countersunk bolt.
Place drip tray under transmission.
Carefully pull out flange shaft with compression spring. Taper ring, thrust washer and compression spring can drop out.

Fig 2: Removing Flange Shaft Oil Seal Using Slide Hammer-Complete Set VW 771 And Additional Part For VW771 VW 771/37

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Remove flange shaft oil seal using Slide Hammer-complete Set VW 771 and Additional Part For VW771 VW 771/37.