Removing Oil Seal For Left Flange Shaft

WARNING: This page is about a different variant/trim than selected.

Remove left wheel.
Remove noise insulation tray.
Remove left noise insulation.
Turn steering to left lock.
Remove drive axle from flange shaft.
Mark installation position of swivel joint bolts on left suspension link and remove bolts.

Fig 1: Removing Bolts

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Fig 2: Separating Left Coupling Rod From Suspension Link And Turn Coupling Rod Upwards

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Separate left coupling rod - 1 - from suspension link and turn coupling rod upwards.
Swing wheel bearing housing outwards.
Raise left drive axle - 2 - between subframe and transmission and secure to suspension strut with wire.
Remove countersunk bolt.
Place drip tray under transmission.
Carefully pull out flange shaft with compression spring. Taper ring, thrust washer and compression spring can drop out.

Fig 3: Pull Out Flange Shaft Oil Seal Using Slide Hammer-Complete Set VW 771 And Additional Part For VW771 VW 771/37

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Pull out flange shaft oil seal using Slide Hammer-complete Set VW 771 and Additional Part For VW771 VW 771/37.