Installing Oil Seal For Left Flange Shaft
WARNING: This page is about a different variant/trim than selected.
- Drive in new seal to stop, taking care not to cant seal.
- Moisten sealing lips of oil seal with ATF.
- Insert flange shaft.
- Apply sealant D 176 404 A2 to tapered section of countersunk bolt.
- Tighten countersunk bolt.
- Install left drive axle to flange shaft.
- Bolt swivel joint to suspension link in its original position.
- Install wheel.
- Finally, check ATF level and top off, refer to ATF level, checking and topping off .
- Install noise insulation tray.