Checking Measurement

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2010 Volkswagen Jetta, 2009 Volkswagen Jetta, 2009 Volkswagen GLI, 2008 Volkswagen Jetta, and 2008 Volkswagen GLI. However, it is still accessible from the selected car via links, so may be relevant.

The selected adjusting shim is installed.

-- Install the measuring tools.

-- If there are protruding housing edges: place an 8 mm washer on the bolt -arrow- for the installation arbor VW 792 on the clutch housing.

Fig 1: Identifying Washers Inserted At Securing Bolt For Assembly Tool VW 792 At Clutch Housing

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Set the dial gauge (3 mm range) with 1 mm preload to "0".

-- Loosen the bolts for the clutch housing to transmission housing in a diagonal sequence until the bolts clear transmission housing and output shaft.

-- For the correctly selected adjustment shim, the dial gauge must now display a value of 0.15 mm to 0.25 mm.