Exhaust System
WARNING: This page is about a different car, the 2010 Volkswagen Jetta, 2009 Volkswagen Jetta, 2009 Volkswagen GLI, 2008 Volkswagen Jetta, and 2008 Volkswagen GLI. However, it is still accessible from the selected car via links, so may be relevant.
- After exhaust system repairs, make sure the exhaust system is not under stress and is far enough from the body. If necessary, loosen the clamping sleeve(s) and align the muffler and exhaust pipe so that there is adequate distance to the body and that the weight is evenly distributed among the suspended mounts.
- The flex joint in the front exhaust pipe must not be bent more than 10°, otherwise it may be damaged.
- Replace gaskets and self-locking nuts.
- The exhaust manifold and the turbocharger are one component. Removing and installing, refer to TURBOCHARGER .
Special tools and workshop equipment required
- Ring Spanner 7-Piece Set3 337
- Torque Wrench (5-50 Nm) V.A.G 1331
- Body Saw V.A.G 1523 A or
- Chain Pipe Cutter VAS 6254