Transmission To Engine Tightening Specifications

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2010 Volkswagen Jetta, 2009 Volkswagen Jetta, 2009 Volkswagen GLI, 2008 Volkswagen Jetta, and 2008 Volkswagen GLI. However, it is still accessible from the selected car via links, so may be relevant.

Transmission to Engine Bolts

Fig 1: Identifying Transmission To Engine Bolt Tightening Sequence

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

Item	Bolt	Quantity	Nm
1	M12 x 55 With a short M8 threaded pin	1	80
2	M12 x 55 With a long M8 threaded pin	1	80
3	M12 x 65	1	80
4	M10 x 50	2	40
5	M10 x 105	1	40
6	M12 x 165 With a short M8 threaded pin Also starter to transmission	1	80
7	M12 x 165 With a short M8 threaded pin Also starter to transmission	1	80
-	M6 x 8 small flywheel cover plate (not present on all engines)	1	10

-A and B- : Alignment sleeves

-- Replace the bolts -1 through 5-.

Transmission Mount Bracket to Transmission Bolts

Fig 2: Identifying Transmission Mount Bracket to Transmission Bolts

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Replace the bolts.

Tighten the bolts -arrows- to 60 Nm + 90° (1/4) additional turn.

Transmission Mount to Transmission Mount Bracket Bolts

Fig 3: Identifying Bolts To Align Engine/Transmission In Installed Location

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Replace the bolts.

Tighten the bolts -arrows- to 60 Nm + 90° (1/4) additional turn.