Transmission Fluid, Checking

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2010 Volkswagen Jetta, 2009 Volkswagen Jetta, 2009 Volkswagen GLI, 2008 Volkswagen Jetta, and 2008 Volkswagen GLI. However, it is still accessible from the selected car via links, so may be relevant.

Special tools and workshop equipment required

Torque Wrench (5-50 Nm) V.A.G 1331
Triple Square Socket Driver 3357

-- Remove the noise insulation. Refer to Description and Operation .

-- Remove the plug -arrow- for checking the transmission fluid level.

Fig 1: Identifying Sealing Plug For Gear Oil Inspection

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

The level is correct when the transmission fluid comes up to the bottom edge of oil filler hole.

-- Install the plug -arrow- with a new seal.

-- Tighten the plug -arrow- to specification. Refer to Fig 2.

Note the following when filling for the first time:

-- Remove the plug -arrow-.

-- Add transmission fluid until it reaches the lower edge of the filler hole.

-- Install the plug -arrow- with a new seal.

-- Tighten the plug -arrow- to specification. Refer to Fig 2.

-- Install the noise insulation. Refer to Description and Operation .

Fig 2: Identifying Different Versions Of Oil Drain Plugs

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

I - Oil filler or drain plug with a multipoint socket head, 45 Nm

II - Oil filler or drain plug with hex socket head, 30 Nm