Transmission, With A Sealing Cap CIRCLIP Or A Plastic Cover: Notes

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2010 Volkswagen Jetta, 2009 Volkswagen Jetta, 2009 Volkswagen GLI, 2008 Volkswagen Jetta, and 2008 Volkswagen GLI. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Input Shaft Sealing Cap Types

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

Special tools and workshop equipment required

Holding Plate VW 309
Holding Fixture VW 313
Transmission Support VW 353
Thrust Tube VW 455 or Sleeve 3160
Slide Hammer-Complete Set VW 771
Kukko Puller 12-14.5 mm 21/1
Kukko Separating Tool 5-60 mm 17/0
Kukko Support 22/1
Bracket 30-211A
Thrust Piece T10143 or Press Tool for Shaft Seal T10180
Drift T10169 or T10362, see Figure.
Thrust Piece T40008
Torque Wrench (5-50 Nm) V.A.G 1331
Hot Air Blower V.A.G 1416
Drip Tray for VAS 6100 VAS 6208