Shift Forks
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2010 Volkswagen Jetta, 2009 Volkswagen Jetta, 2009 Volkswagen GLI, 2008 Volkswagen Jetta, and 2008 Volkswagen GLI. However, it is still accessible from the selected car via links, so may be relevant.
Special tools and workshop equipment required
- Thrust Plate VW 402
- Punch VW 411
- Tube Trans. Drive Shaft VW 426
- Thrust Pad 16.5/28 mm Dia. VW 431
- Kukko Extractor 18.5-23.5 mm 21/3
- Kukko Support 22/1
- Insulation Mat
- Can be removed and installed by hand.
- Selector Shaft with Selector Fork, for 1st and 2nd Gear
- Selector Shaft with Selector Fork, for 3rd and 4th Gear
- Selector Shaft with Selector Fork, for 5th and 6th Gear
- Reverse Gear Selector Fork
- On the selector shaft for the reverse gear shift fork Figure.
- From transmission build date 6 March 2006, ball sleeve has been omitted, see "Ball Sleeve" in item: 6
- Sliding omission
- Reverse gear selector fork is adapted.
- If the shaft for the reverse gear selector fork is deleted, there is bearing on the shift rod for the 5th and 6th gear shift fork Figure.
- Reverse gear selector fork differentiation, refer to Fig 2.
- Ball Sleeve
| Dimension "a" mm | Reverse Gear Selector Fork | Mounting |
|---|---|---|
| 24 | with a ball sleeve | on the shaft for the reverse gear shift fork, refer to Figure. |
| 18 | without a ball sleeve | |
| 15 | without a ball sleeve | Selector shaft with selector fork for 5th and 6th gear, refer to Figure. |
A - Internal puller 18 to 23 mm, for example, kukko extractor 18.5-23.5 mm 21/3
B - Counter-support for example, kukko Support 22/1