Selector Mechanism Overview, From 03.09
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2010 Volkswagen Jetta, 2009 Volkswagen Jetta, 2009 Volkswagen GLI, 2008 Volkswagen Jetta, and 2008 Volkswagen GLI. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
Move the selector lever into "P" and set the parking brake before working with the engine running.
- Selector Handle with Cover
- Do not remove the handle unnecessarily. For emergency release, only the cover must be removed. Refer to SELECTOR LEVER MANUAL RELEASE .
- Pull the button out past its pressure point before removing the handle. Secure the button with a cable tie or some suitable wire. This prevents the button from being pushed back into the handle accidentally.
- Removing and installing, refer to SELECTOR HANDLE WITH COVER .
- Selector Mechanism with Selector Lever and Selector Lever Cable
- With the shift lock solenoid -N110-.
- The cable is not lubricated.
- Removing and installing, refer to SELECTOR MECHANISM WITH LEVER AND CABLE, FROM 03.09 .
- Checking, refer to SELECTOR LEVER CABLE, CHECKING .
- Adjusting SELECTOR LEVER CABLE, ADJUSTING .
- Bolt
- 8 Nm
- Nut
- 8 Nm
- Quantity: 4
- Selector Housing
- Adjusting Bolt
- 13 Nm
- Lock Washer
- Always replace after removing.
- Lock Washer
- Always replace after removing.