LEMON Manuals: Even more car manuals for everyone
Home >> Volkswagen >> 2005 >> Jetta TDI, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 1 (3.2L VR6 4V Engine Mechanical, Fuel Injection Ignition, Engine Code(S): BJS) >> 17 - Engine - Lubrication >> Lubrication system components, removing and installing >> Lubrication system components, removing and installing

Lubrication system components, removing and installing

WARNING: This page is about a different car, the 2004 Volkswagen R32. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
  • When performing repair work, secure engine to engine and transmission holder VAS 6095 or holding fixture VW 540 with supplementary set VW 540/1 B.
  • The oil level must not be above the max. mark - danger of damage to catalytic converter!
  • If large quantities of metal particles or abraded material are detected during engine repairs, it may be an indication for a damaged crankshaft or rod bearings. To prevent further damage, perform the following steps after the repair:
  • Carefully clean oil passages
  • Replace oil non-return valve
  • Replace oil injection jets
  • Replace oil cooler
  • Replace oil filter

Engine oil, refer to Engine oil 

Assembly overview, refer to Assembly overview 

Oil filter housing, assembly overview, refer to Oil filter housing, assembly overview  

Oil pump, assembly overview, refer to Oil pump, assembly overview 

Oil pan, removing and installing, refer to Oil pan, removing and installing 

Oil pressure and oil pressure switch, checking, refer to Oil pressure and oil pressure switch, checking 

scientia non olet · About LEMON Manuals