Relay panel integrated with Vehicle Electrical System Control Module J519, emoving and installing
NOTE:
- The relay panel integrated with Vehicle Electrical System Control Module J519 is permanently attached and cannot be serviced separately.
- If Vehicle Electrical System Control Module J519 is to be replaced, the work procedure to read out the coding stored in the module must always be performed.
Removing:
CAUTION:
- Switch off all electrical consumers.
- Switch ignition off and remove ignition key.
- Remove drivers footwell cover → 68 INTERIOR EQUIPMENT .
- Remove drivers storage compartment where applicable → 68 INTERIOR EQUIPMENT .
- Disengage electrical connection lock - 1 - in - direction of arrow A -.
- Disengage electrical connection lock - 2 - at Vehicle Electrical System Control Module J519 in - direction of arrow B -.
NOTE:
- Harness connectors of Vehicle Electrical System Control Module J519 and of relay carrier at vehicle electrical system control module, at left instrument panel, can only be disconnected if lock is brought into position "OPEN" beforehand.
- Disconnect all electrical connections to relay panel.
NOTE:
- The number of electrical connections depends on vehicle equipment.
- Unclip Vehicle Electrical System Control Module J519 with relay panel from latches - arrows C -.
- Pull Vehicle Electrical System Control Module J519 with relay panel downward and out of bracket in opposite direction of travel.
Installing:
Install in reverse order of removal, noting the following:
NOTE:
- Electrical connection locks can only be brought into position "CLOSE" when all connections are connected "correctly".