Wiper arms, removing and installing

Removing:

Remove wiper arms.

Installing:

NOTE:

Wiper arm nuts must only be torqued after wiper blade park position is checked and adjusted.

Deactivate APP function → Windshield wiper - Alternating Park Position (APP) function, deactivating if not already done by this time.
Operate wipers briefly, allow to run to park position and then switch off ignition.

Fig 1: Identifying Wiper Arm Nuts

GW00001180

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Mount wiper arms to wiper shaft and loosely install nuts - arrows - (do not tighten).
Adjust wiper blade park position → Wiper blade park position, checking and adjusting .
Reinstall covers and trim.