Relay/fuse panel under left instrument panel, removing and installing

CAUTION: When disconnecting and reconnecting battery terminals, observe all applicable Notes and torque specifications, as well as instructions on performing OBD program and electrical system function checks as specified in → Battery, disconnecting and connecting .

Removing:

Disconnect battery → Battery, disconnecting and connecting .
Remove drivers storage compartment where applicable → 68 INTERIOR EQUIPMENT .

Fig 1: Relay/Fuse Panel Mounting Screws

GW00012217

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Remove screws - arrows -.

Fig 2: Relays In Relay Carrier

GW00012218

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Remove relays - arrows - from relay carrier.

NOTE:

The number of relays is dependent on vehicle equipment.

Fig 3: Clipping Retaining Tabs Outward And Pressing Connectors Through Relay Carrier

GW00012219

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Clip retaining tabs in - direction of arrow - outward and then press connectors - 1 - through relay carrier.

Fig 4: Relay Panel Retainer

GW00012220

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Release retaining tab - 1 - for relay carrier in - direction of arrow - and remove relay carrier.

Installing:

Install in reverse order of removal, noting the following:

First clip connector into relay carrier.

Fig 5: Placing Relay Carrier Into Guide And Engaging Relay Carrier

GW00012221

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Place relay carrier - 2 - into guide - 1 - and then engage relay carrier.