Ignition/Starter Switch, removing and installing: Notes

CAUTION: When disconnecting and reconnecting battery terminals, observe all applicable Notes and torque specifications, as well as instructions on performing OBD program and electrical system function checks as specified in → Battery, disconnecting and connecting .

Removing:

Disconnect battery → Battery, disconnecting and connecting .

Fig 1: Ignition/Starter Switch And Harness Connector

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Disconnect electrical connection - 2 - from ignition/starter switch - 1 -.
Release ignition/starter switch using a small screwdriver - arrows -.
Pull out ignition/starter switch - 1 - from steering lock housing.

Installing:

Insert ignition/starter switch into steering lock housing until it engages audibly.

Fig 2: Position Of Key In Lock Cylinder

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Insert ignition key into lock cylinder and turn it into position "Drive".

NOTE:

Key must be located in "Drive" position.

Key positions of lock cylinder:

1 - Position "Hold"

2 - Position "Drive"

3 - Position "Start"

Install all components in reverse order of removal.