High Beam Headlamp Bulb M30 / M32, eplacing
NOTE:
- Left High Beam Headlamp Bulb is illustrated.
Removing:
CAUTION:
- Switch off all electrical consumers.
- Switch ignition off and remove ignition key.
- Remove cover - 1 -.
- Disconnect electrical connection - 2 -.
- Press spring retaining wire - 2 - in - direction of arrow - under catches - 1 - and fold spring retaining wire - 2 - upward.
- Remove High Beam Headlamp Bulb - 1 - from headlamp.
Installing:
CAUTION:
- Do not touch glass portion of bulb with bare hands. Even the smallest amount of moisture and/or contaminants from fingers that evaporates on the bulb during operation can cause the glass to cloud over.
- When installing cap, ensure proper seating. Water intrusion will damage headlamp.
Install in reverse order of removal, noting the following:
- Insert High Beam Headlamp Bulb - 1 - into recesses - arrows - on headlamp.
- Reconnect electrical connection
- Check headlamp function.
- Check headlamp adjustment and adjust if necessary → 01 - Maintenance .