Brake Light Switch, From 10.05.2005
On vehicles before 10.05.2005, brake light switch was located on brake pedal. Refer to BRAKE LIGHT SWITCH, THROUGH 10.05.2005 .
Removing
-- Remove engine cover.
-- On some vehicles, intake hose must be removed.
-- Disconnect the connector -1- from Brake Light Switch -F-.
-- Remove bolt -2- from brake master cylinder.
-- Pull the brake light switch -3- downward and off from the brake master cylinder and remove it from the retaining tab at the top -4-.
Installing
-- Installation is performed in the reverse order of removal.
Tightening Specifications
| Component | Tightening Specifications |
|---|---|
| Torx bolt to brake master cylinder | 5 Nm |