Adjustment Buffer, Adjusting

NOTE:

The following adjustment is only for the right adjusting buffer. Adjustment for the left adjusting buffer is derived accordingly from this.

-- Loosen stud screw -1- far enough until it is visible in rubber buffer.

Fig 1: Identifying Adjustment Buffer Locking Screw -1- And Dimension -a-

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Now pull notched slider out of adjustment stop.

-- Set notched slider to dimension -a- = 12.5 mm.

Fig 2: Identifying Notched Slider Adjustment Dimension

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Close rear lid to initial locking position using light pressure over the center.

-- Open rear lid again.

Fig 3: Identifying Adjustment Buffer Locking Screw -1- And Dimension -a-

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Screw in clamping screw -1- for adjusting buffer to a depth of dimension -a- = 25 mm.

-- Check the adjustment.