"Aero-wiper" blades, removing and installing
Removing:
NOTE:
- Driver and passenger wiper blades are different lengths. Damage will result if wiper blades are interchanged.
- To ensure proper wiper performance, only grab/lift Aero-wiper blades at the mounting pivot on wiper arm when removing and installing.
- To remove wiper blades, wiper arms must be set to "service/winter position". The "service/winter position" is activated by operating windshield wiper lever in "touch sweep" position within 10 seconds after switching off ignition.
- Set wiper arms to "service/winter position" by operating windshield wiper lever in "touch sweep" position within 10 seconds after switching off ignition.
- Fold wiper arm away from windshield.
- Turn wiper blade - 1 - on wiper arm until it reaches stop - arrow A -.
- Pull off wiper blade - 1 - from wiper arm pivot - arrow B -.
Installing:
- Slide wiper blade onto axle of wiper arm.
- Turn wiper blade on wiper arm axle until it reaches stop.
- Carefully fold wiper arm back onto windshield.