HID Lamp bulbs, eplacing
CAUTION:
- Switch off all electrical consumers.
- Switch ignition off and remove ignition key.
NOTE:
- Left HID Lamp is illustrated.
Removing:
- Remove headlamp.
- Turn cover - 1 - in - direction of arrow - and remove.
- Disconnect electrical connection - 1 -.
NOTE:
- The connector is automatically ejected when the HID Lamp Igniter Unit N195 is removed.
- Rotate HID Lamp Igniter Unit N195 - 1 - as indicated by marking "OPEN", nd remove.
CAUTION:
- The physical and mechanical properties of HID bulbs are very sensitive. Internal pressure of HID glass bulb may exceed 100 bar (in operation). Bulb temperature may exceed 700 degrees Celsius.
- Danger of explosion and burning.
- Always wear safety glasses and gloves when removing and installing HID bulb.
- Rotate bulb retainer - 1 - in - direction of arrow - and remove.
- Carefully remove HID Lamp bulb - 1 - from mount.
Installing:
Install in reverse order of removal, noting the following:
CAUTION:
- Do not touch glass portion of HID bulb with bare hands. Even the smallest amount of moisture and/or contaminants from fingers that evaporates on the bulb during operation can cause the glass to cloud over.
- When installing cap, ensure proper seating. Water intrusion will damage headlamp.
CAUTION:
- HIGH VOLTAGE!
- Danger of explosion and burning.
- The control modules for HID lamps must never be operated (headlamps turned on) without an HID lamp.
- HID bulbs must only be operated (headlamps turned on) when installed in the headlamp housing.
- Never look directly at an operating HID bulb. The UV emissions of an HID bulb are approximately 2.5 times that of a comparable halogen bulb.
- Check HID Lamp function.
- Perform headlamp basic setting and check headlamp adjustment → 01 - Maintenance .