Starter - 2.0L TFSI engine and manual transmission, removing and installing
Special tools, testers and auxiliary items required
- Torque wrench VAG 1331 (or equivalent 5 - 50 Nm)
- Torque wrench VAG 1332 (or equivalent 40 - 200 Nm)
- Spring clamp pliers VAS 5024
Removing:
- Disconnect battery → Battery, disconnecting and connecting .
- Remove screws - arrows -.
- Disconnect electrical connection - arrow -.
- Loosen spring clamp - arrow - using Spring clamp pliers VAS 5024.
- Remove engine cover by pulling upwards - arrows - from engine.
- Slide protective cap in direction of - arrow - downward from starter solenoid.
- Disconnect electrical connections at starter solenoid terminal 30 - 1 - and terminal 50 - 2 -.
- Remove Ground (GND) cable from upper starter bolt - arrow -.
- Remove upper starter bolt - arrow -.
- Remove lower engine compartment noise insulation → 50 BODY FRONT
- Remove nut - 1 - from lower starter bolt.
- Remove harness retainer - 2 -.
- Remove lower starter bolt - arrow -.
- Remove starter downwards.
Installing:
Install in reverse order of removal, noting the following:
- Tighten all fasteners according to value in table → Starter, tightening torques .