General information

The windshield wiper system is controlled by the Wiper Motor Control Module J400 which is integrated with Drivers Windshield Wiper Motor V216.

Fig 1: Identifying Windshield Wipers

Courtesy of VOLKSWAGEN UNITED STATES, INC.

To remove wiper blades, wiper arms must be set to "service/winter position". The "service/winter position" is activated by operating windshield wiper lever in "touch sweep" position within 10 seconds after switching off ignition Owners Manual.

NOTE:

In order to prevent potential damage to wiper arms, the windshield wipers will not function, or will cease functioning should the front hood be opened.
Additional information:

Owners Manual

Wiring Diagrams Component Locations

Self Study Program - Course Number 89103 "The 2005 new Jetta New Model Introduction"

Self Study Program - Course Number 873403 "The 2005 new Jetta - Electrical System"

CAUTION: When disconnecting and reconnecting battery terminals, observe all applicable Notes and torque specifications, as well as instructions on performing OBD program and electrical system function checks as specified in → Battery, disconnecting and connecting .