Headlamps with High Intensity Gas Discharge (HID) lamps, assembly - component overview
- After performing any repairs or service that could affect headlamp aim, check/adjust aim → 01 - Maintenance
- Tightening torques → Headlamps, tightening torques
1 - Ventilation hose
- on headlamp housing
2 - Left Headlamp Beam Adjustment Motor V48 and Right Headlamp Beam Adjustment Motor V49
- Headlamp manufacturer: AL (Automotive Lamping)
- The initial removal of Left Headlamp Beam Adjustment Motor V48 and Right Headlamp Beam Adjustment Motor V49 requires a repair set Parts Catalog
- Removing and installing → Headlamp Beam Adjusting Motors V48 / V49, emoving and installing
3 - Screws
- for Left Headlamp Beam Adjusting Motor V48 and Right Headlamp Beam Adjusting Motor V49
4 - Cover
5 - HID Lamp Igniter Unit N195
6 - HID Bulb retainer
- for Left High Intensity Gas Discharge (HID) Lamp L13 and Right High Intensity Gas Discharge (HID) Lamp L14
7 - Left High Intensity Gas Discharge (HID) Lamp L13 and Right High Intensity Gas Discharge (HID) Lamp L14
- Type D2S, 35W
- Replacing
8 - Screw
- 4 Nm
- on top of headlamp
9 - Headlamp housing
- Removing and installing → Headlamps, removing and installing:
- Correcting installation position of headlamp → Headlamp installation position, correcting
- Servicing headlamp securing lugs → Headlamp housing securing lugs, servicing
10 - Headlamp Range Control Module J431
- Removing and installing → Headlamp Range Control Module J431, emoving and installing
- Coding
- If Headlamp Range Control Module J431 is coded, basic setting of headlamps must be performed after coding the control module → 01 - Maintenance .
11 - Left Front Level Control System Sensor G78
- Removing and installing → Vehicle level sensors, emoving and installing
- Checking → Level control system sensors, hecking
12 - Left Rear Level Control System Sensor G76
- Removing and installing → Vehicle level sensors, emoving and installing
- Checking → Level control system sensors, hecking
13 - Adjustment guide
- Correcting installation position of headlamp → Headlamp installation position, correcting
14 - Screw
- 4 Nm
- on headlamp at bottom
15 - Left High-intensity Gas Discharge Lamp Control Module J343 and Right High-intensity Gas Discharge Lamp Control Module J344
- not capable of On Board Diagnostic (OBD)
- Removing and installing → High-intensity Gas Discharge Lamp Control Module J343 / 344, emoving and installing
16 - Screws
- for Left High-intensity Gas Discharge Lamp Control Module J343 and Right High-intensity Gas Discharge Lamp Control Module J344
17 - Left High Beam Headlamp M30 and Right High Beam Headlamp M32
- Lamp H7U 12 V, 55 W
- Replacing
18 - Left Front Turn Signal Lamp M5 and Right Front Turn Signal Lamp M7
- Lamp 12 V, H2 WLL 21 W
- Replacing
19 - Left Parking Lamp M1 and Right Parking Lamp M3
- Lamp 12 V, W 5 W
- Replacing
20 - Cover
- for Left Front Turn Signal Lamp M5 and Right Front Turn Signal Lamp M7 and for Left Parking Lamp M1 and Right Parking Lamp M3
21 - Cover
- for Left High Beam Headlamp M30 and Right High Beam Headlamp M32