Glove Compartment Lamp W6, emoving and installing

Special tools, testers and auxiliary items required

Fig 1: Wedge 3409

GW00002640

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Trim removal wedge VAS 3409

Removing:

CAUTION:

Switch off all electrical consumers.
Switch ignition off and remove ignition key.
When removing switches, trim, covers or displays, prevent damage to visible areas of the instrument panel by always applying appropriate tape to area surrounding the component, and the tools being used (screwdrivers, wedges etc.).

Fig 2: Prying Out Diffusion Lens Using Trim Removal Wedge

GW00012157

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Carefully pry out diffusion lens using trim removal wedge VAS 3409 or screwdriver.

Fig 3: Glove Compartment Light Electrical Connection

GW00012158

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Disconnect electrical connection - arrow -.

Replacing lamp:

Fig 4: Retaining Tabs And Heat Shield

GW00012159

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Disengage retaining tabs - 1 - and remove heat shield - 2 - from diffusion lens of light.

Fig 5: Prying Bulb From Socket

GW00012160

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Carefully pry lamp out of socket.
Replace (12 V, 5 W) glass socket lamp.

Installing:

Install in reverse order of removal, noting the following:

Check function of glove compartment switch. Glove compartment light must not light up with cover closed.