Wheel hub, pressing in

Fig 1: Center Assembly With Clip E-76-2

Courtesy of VOLKSWAGEN UNITED STATES, INC.

• Center assembly with clip E-76-2.
• Position wheel hub on wheel bearing.

Fig 2: Pressing In Wheel Hub

Courtesy of VOLKSWAGEN UNITED STATES, INC.

• Position thrust piece - 1  - on back of wheel bearing housing.
• Install piston cylinder - 2  - with bolt - 3  - , special tool - 4  - and thrust piece - 5  -.

1 - Press piece E-5

2 - Piston cylinder HKZ-15

3 - Removal rods E-0-217

4 - Special nut E-8-214

• Build-up pressure with foot pump.
• Now check that all tools are correctly centered.
• Press wheel hub on by pumping foot pump.

The shoulder - arrow  - of the thrust piece E-5 must face toward the special nut - 4  -.