Control arm, removing and installing: Installing
Installation is carried out in the reverse sequence.
- Install and fasten wheel → Torques for wheel bolts, tightening .
| Torque specifications: | |
| Ball joint to control arm Use new bolts! | 20 Nm + quarter turn (+90 ° ) |
| Pendulum support to subframe | 25 Nm |
| Forward bolt for control arm Rearward bolt for control arm Use new bolts! | 70 Nm + quarter turn (+90 ° ) |
| Coupling rod to stabilizer bar | 30 Nm |
| Drive shaft to flanged shaft | |