Part I
WARNING: This page does not describe the selected car, but rather 20 other vehicles, including the 2009 Volkswagen Golf, 2008 Volkswagen Golf, 2007 Volkswagen Golf, 2006 Volkswagen Golf, and 2005 Volkswagen Jetta. However, it is still accessible from the selected car via links, so may be relevant.
Part I
1 - 45 Nm
2 - Engine bracket
3 - 25 Nm
4 - Bracket
- Depending on version
5 - Bracket
6 - Hose clip
7 - 10 Nm
- For engine cover
- Depending on version
8 - 20 Nm
- Depending on version
9 - Toothed belt guard, upper part
10 - Toothed belt guard, center section
11 - 20 Nm
12 - Washer
13 - Tensioning roller
- Checking semi-automatic toothed belt tensioning roller. Refer to Semi-automatic toothed belt tensioning roller, checking
14 - Toothed belt
- Mark direction of rotation before removing
- Check for wear
- Do not kink
- Removing and installing, tensioning. Refer to Engine codes AEG, AVH, AZG, BEV .
15 - Rear toothed belt guard
16 - Washer
- Note Part No.
17 - O-ring
- Always replace
18 - Coolant pump
- Check for ease of movement
- If damaged or leaking replace complete
- Removing and installing. Refer to Coolant pump, removing and installing
19 - 15 Nm
20 - Crankshaft toothed belt sprocket
21 - 90 Nm plus 1/4 turn (90 ° )
- Always replace
- Threads and shoulder must be free of oil and grease
- Use counterhold tool 3415 to loosen and tighten
22 - Toothed belt guard, lower part
23 - 10 Nm
- Always replace
24 - Electro-magnetic coupling
- Air conditioning compressor
25 - Belt pulley
- For power steering pump
26 - Poly V-belt
- Mark direction of rotation before removing
- Check for wear
- Do not kink
- Removing and installing. Refer to Poly V-belt, removing and installing
27 - Belt pulley/vibration damper
- Can only be installed in one position; holes are offset
- Note position when installing toothed belt. Refer to Engine codes AEG, AVH, AZG, BEV
28 - 25 Nm
29 - Tensioning element for poly V- belt
- Turn with open end wrench to loosen ribbed poly V-belt. Refer to Poly V-belt, removing and installing