Check DTC Memory
WARNING: This page does not describe the selected car, but rather 26 other vehicles, including the 2009 Volkswagen Golf, 2008 Volkswagen Golf, 2007 Volkswagen Golf, 2006 Volkswagen Golf, and 2006 Volkswagen GTI. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
The vehicle V.A.G 1552 System tester can be used instead of the V.A.G 1551 scan tool, however a print-out is not possible.
- Connecting scan tool. Refer to Scan tool, connecting . Initiating On Board Diagnostic (OBD). Refer to Seat adjustment, initiating On Board Diagnostic (OBD) .
- Switch on printer with Print button (warning lamp in button lights up).
Indicated on display:
| Rapid data transfer HELP Select function XX |
- Press buttons -0- and -2- (the function "Check DTC memory" is entered with 02).
Indicated on display:
| Rapid data transfer Q 02 - Check DTC memory |
- Press "Print" button
- Confirm entry with the -Q- button.
The number of stored malfunctions appears in the display.
| X DTCs recognized! |
The stored malfunctions are displayed and printed out one after the other.
NOTE:
If a DTC is recognized:
- 1. Repair malfunction
- 2. Erase DTC memory (function 05).
- 3. Check DTC memory again (function 02).
- The DTCs printed out can be repaired with aid of DTC table. Refer to DTC table .
- The function "Read Measuring Value Block", Read Measuring Value Block , and Display group overview, Display group overview , are additional aids.
The measured value block is divided into 6 display group numbers. The assignment of the individual display zones can be taken from the display group overview . Refer to Display group overview .
If "No DTC recognized" is displayed the program will return to the initial position after pressing the → button.
| No DTC recognized! → |
Indicated on display:
| Rapid data transfer HELP Select function XX |
If something else is displayed:
Refer to Scan tool operating instructions
- Press buttons -0- and -6- to end the output.
Indicated on display:
| Rapid data transfer Q 06 End output |
- Confirm entry with the -Q- button.
Indicated on display:
| Rapid data transfer HELP Enter address word XX |
- Switch off ignition.
- Disconnect connector to V.A.G 1551 scan tool.