Erase DTC memory
WARNING: This page does not describe the selected car, but rather 26 other vehicles, including the 2009 Volkswagen Golf, 2008 Volkswagen Golf, 2007 Volkswagen Golf, 2006 Volkswagen Golf, and 2006 Volkswagen GTI. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
The vehicle V.A.G 1552 System tester can be used instead of the V.A.G 1551 scan tool, however a print-out is not possible.
- Connecting scan tool. Refer to Scan tool, connecting . Initiating On Board Diagnostic (OBD). Refer to Convenience system, initiating On Board Diagnostic (OBD) .
Prerequisites:
- DTCs are repaired
- Functional check has been carried out
- DTC memory checked again
Indicated on display:
| Rapid data transfer HELP Select function XX |
- Press buttons -0- and -5- (the function "Erase DTC memory" is entered with 05).
Indicated on display:
| Rapid data transfer Q 05 Erase DTC memory |
- Confirm entry with the -Q- button.
Indicated on display:
| Rapid data transfer → DTC memory is erased! |
- Press → button.
Indicated on display:
| Rapid data transfer HELP Select function XX |
NOTE:
- If this appears in the display, the test sequence is faulty.
- Adhere strictly to test sequence; first of all check DTC memory, then erase memory.
- Press buttons -0- and -6- to end the output.
Indicated on display:
| Rapid data transfer Q 06 End output |
- Confirm entry with the -Q- button.
Indicated on display:
| Rapid data transfer HELP Enter address word XX |
- Switch off ignition.
- Disconnect connector to V.A.G 1551 scan tool.