Introducing On Board Diagnostic (OBD) for airbag
WARNING: This page does not describe the selected car, but rather 26 other vehicles, including the 2009 Volkswagen Golf, 2008 Volkswagen Golf, 2007 Volkswagen Golf, 2006 Volkswagen Golf, and 2006 Volkswagen GTI. However, it is still accessible from the selected car via links, so may be relevant.
- Connecting scan tool. Refer to Scan tool, connecting .
- Switch on printer with Print button (warning lamp in button lights up).
- Switch on ignition.
Indicated on display:
| Rapid data transfer HELP Enter address word XX |
- Press buttons -1- and -5- (the address word of the vehicle system to be tested "Airbag" is entered with 15).
Indicated on display:
| Rapid data transfer Q 15 Airbag |
- Confirm entry with the -Q- button.
Indicated on display:
| Rapid data transfer HELP Select function XX |
NOTE:
- If one of the malfunction messages opposite appears in the display, the possible causes of the malfunction can be printed out with the HELP button.
- Ignition must be switched on.
- Malfunctions have occurred at the start of or during the program (external interference?).
NOTE:
- Check diagnosis wires as well as voltage supply and Ground connection.
- After repairing the possible causes of the fault, once again enter the address word 15 for "Airbag" by pressing -1- and -5- buttons and confirm with the -Q- button.
Indicated in display after entering the address word 15:
| Rapid data transfer Tester sends the address word 15 |
and then the following appears in the display:
Indicated on display (see parts catalog for latest control module version).
| 1J0 909 608 D AIRBAG VW 3-S V03 → Coding 00068 WSC12345 |
- Press → button.
Indicated on display:
| Rapid data transfer HELP Select function XX |