Transmission Housing And Selector Mechanism, Removing And Installing
1 - Countersunk head bolt, 25 Nm
2 - Flanged shaft with spring
- Removing and installing. Refer to Oil seal for left flanged shaft, replacing
- Assembling. Refer to Differential, disassembling and assembling
3 - Back-up light switch, 20 Nm
4 - Oil seal
- Always replace
5 - Oil drain plug, 30 Nm
- Always replace
6 - Oil seal
- Always replace
7 - Cover plate
8 - Hex bolt, 20 Nm
- Always replace
9 - Hex bolt, 20 Nm
- For selector shaft item Transmission housing and selector mechanism, removing and installing to cover plate
- Always replace
10 - O-ring
- Always replace
- Insert in groove in cover plate
11 - Locking bolt, 15 Nm
- For selector shaft gate
- Always replace
- Insert with locking fluid D 000 600 A2
12 - Hex bolt, 25 Nm plus 1/8 turn (45 ° ) further
- With attached washer
- Always replace
13 - Hex bolt, 25 Nm plus 1/8 turn (45 ° ) further
- Without washer
- Always replace
14 - Selector shaft
- Disassembling and assembling. Refer to Transmission selector mechanism, disassembling and assembling , Selector mechanism, disassembling and assembling
15 - Hex bolt, 20 Nm
- Always replace
16 - Selector mechanism cover
- Disassembling and assembling. Refer to Transmission selector mechanism, disassembling and assembling , Selector mechanism, disassembling and assembling
17 - Clutch housing
- Servicing. Refer to Clutch housing, servicing
18 - Transmission housing
- Servicing. Refer to Transmission housing, servicing