Subframe, removing and installing: Installing
Before inserting bolts for subframe, position steering gear on subframe and insert bolts for steering gear
The threaded sleeve - 1 - must seat in subframe hole.
Further installation in reverse order
After installing check position of steering wheel during a test drive.
If steering wheel is not in straight ahead position the front axle alignment must be checked!
| Torque specifications | |
| Ball joint to control arm Use new bolts! | 20 Nm + quarter turn (+90 ° ) |
| Pendulum support to subframe | 25 Nm |
| Pendulum support to transmission | |
| M 10 x 70 M 10 x 30 | 50 Nm 50 Nm |
| Pendulum support at transmissions for vehicles with transmission 02T | |
| M 10 x 70 M 10 x 30 | 40 Nm + 45 ° 40 Nm + 45 ° |
| Steering gear to subframe Use new bolts! | 20 Nm + quarter turn (+90 ° ) |
| Coupling rod to stabilizer bar | 30 Nm |
| Subframe to body Use new bolts! | 100 Nm + quarter turn (+90 ° ) |