P.A.S. power steering pump, vehicles with low mounted power steering pump, removing and installing: Installing

• Fill power steering pump with hydraulic fluid.

  Fill the pump with fluid through the intake line.

• Turn hub by hand until oil runs out of the pressure side.
• Install power steering pump on bracket and tighten bolts to 25 N.m (18 ft. lb).
• Install intake hose and install spring-type clip.

  The mark - arrow A -  must align with casting seam - arrow -  .

  The spring-type clip must close off mark - arrow B -. 

Fig 1: Installing Intake Hose And Spring-Type Clip
Courtesy of VOLKSWAGEN OF AMERICA, INC.
• Install new sealing rings onto banjo bolt.
• Tighten banjo bolt to 38 N.m (28 ft. lb).

Installation is continued in reverse sequence