Removing intake line

Manufacturer recommends that the flexible pliers from tool set VAS 5024 be used to remove the intake line lower spring spring-type clip.

• Unclip all electrical cables and hoses.
• Open spring-type clamps - 1 -  with flexible pliers.
• Remove intake line - B -  .
Fig 1: Removing Intake Line
Courtesy of VOLKSWAGEN OF AMERICA, INC.
• Clamp off suction hose with hose clamps 3094.
Fig 2: Clamping Off Suction Hose With Hose Clamps 3094
Courtesy of VOLKSWAGEN OF AMERICA, INC.
• Open spring clamp - 3 -  and pull off intake hose

Use assembly tool for spring-type clip pliers VAS5024 for this.

• Clamp return hose with hose clamp 3094.
Fig 3: Clamping Return Hose With Hose Clamp 3094
Courtesy of VOLKSWAGEN OF AMERICA, INC.
• Remove banjo bolt - 2 -  .
• Close off the pressure line with a plastic bag or similar.
• Remove hex bolts - 1 -  and - 2 -  .
Fig 4: Removing Power Steering Pump Hex Bolts
Courtesy of VOLKSWAGEN OF AMERICA, INC.
• Take out pump.