Transmission Fluid Temperature Sensor G93 With Wiring Harness, Removing And Installing

Transmission Fluid Temperature Sensor G93 cannot be separated from the wiring harness.

Removing 

• Remove valve body, refer to Valve body, removing and installing  .
• Remove torque converter housing, refer to Transmission, disassembling and assembling  .
• Remove bearing and differential cage.
• Remove ATF screen.

Fig 1: Disconnecting Connectors Off Sensors

Courtesy of VOLKSWAGEN UNITED STATES, INC.

• Disconnect connectors off sensors - 1  - and - 2  -.
• Remove retainer - 4  - arrow  -.
• Remove Transmission Fluid Temperature Sensor G93 - 3  -.
• Turn transmission.
• Remove cover, refer to Transmission, disassembling and assembling  .

Fig 2: Attention (Do Not Turn Back Transmission Before Cover Is Reinstalled)

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Do not turn back transmission before cover is reinstalled. Otherwise, clutch "K2/K3" and other components will fall out.

Disconnect connector off Transmission Input Speed (RPM) Sensor G182 - 1  -.

Fig 3: Removing Sensor Bolts And Remove

Courtesy of VOLKSWAGEN UNITED STATES, INC.

• Remove sensor bolts and remove.
• Remove Transmission Fluid Temperature Sensor G93 with wiring harness downwards.

Installing 

• Guide wire for sensor Transmission Input Speed (RPM) Sensor G182 from beneath through transmission housing.

Fig 4: Pushing Connector Onto Sensor And Install Sensor

Courtesy of VOLKSWAGEN UNITED STATES, INC.

• Push connector onto sensor and install sensor. Tighten bolt to 8 Nm.
• Install cover, refer to Install cover  .
• Turn transmission.
• Install Transmission Fluid Temperature Sensor G93 and tighten bolts to 8 Nm.
• Connect connectors for Vehicle Speed Sensor (VSS) G68 and Intermediate Shaft Speed Sensor G265.
• Install wiring harness retainer and tighten bolt to 8 Nm.
• Guide wiring into valve body housing.
• Install ATF strainer.

Install remaining parts, refer to Transmission, assembling  .