Multi-Function Transmission Range (TR) Switch F125, Installing And Adjusting

Fig 1: Placing Multifunction Switch F125 On Selector Shaft

Courtesy of VOLKSWAGEN UNITED STATES, INC.

• Place multifunction switch F125 on selector shaft.

Installation position:

Fig 2: Groove In Selector Shaft Must Line Up With Mark On Multi-Function Transmission Range (TR) Switch F125

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Groove - 1  - in selector shaft must line up with mark - 2  - on Multi-Function Transmission Range (TR) Switch F125.

Fig 3: Tighten Securing Bolts For Multi-Function Transmission Range (TR) Switch F125 Until Finger-Tight

Courtesy of VOLKSWAGEN UNITED STATES, INC.

• Tighten securing bolts - arrows  - for Multi-Function Transmission Range (TR) Switch F125 until finger-tight.
• Place setting gauge on selector shaft and secure it.
• Move selector shaft lever on transmission to position "N".
• Turn switch so that dowel hole in switch housing - 1  - lines up with hole in setting gauge.

Fig 4: Pushing In Dowel Pin Of Setting Gauge

Courtesy of VOLKSWAGEN UNITED STATES, INC.

• Push in dowel pin - 2  - of setting gauge.
• Tighten securing bolts - arrows  - for Multi-Function Transmission Range (TR) Switch F125.

Fig 5: Locating Selector Lever Nut And Multifunction Switch Connector

Courtesy of VOLKSWAGEN UNITED STATES, INC.

• Connect connector - 2  - wire for multifunction switch.
• Push lever - 1  - onto selector shaft.

Fig 6: Locating Selector Lever Nut And Multifunction Switch Connector

Courtesy of VOLKSWAGEN UNITED STATES, INC.

• Tighten nut - arrow  -.
• Install selector lever cable, refer to Selector lever cable, removing and installing  .
• Install battery and battery holder. Refer to 27 BATTERY, STARTER, GENERATOR, CRUISE CONTROL .
• Connect Ground (GND) strap to battery.
• Code radio, refer to 91 RADIO, TELEPHONE, NAVIGATION, TRIP COMPUTER .