"K4" Components From Above, Overview

The clutch will now be disassembled for cleaning. No repairs can be made.

1 - Clutch housing "K4"

2 - Piston

3 - Spring

4 - Spring seat

5 - Retaining ring

• Ring will not be replaced. Therefore, remove and install carefully, not over-stretching it with force.

6 - Outer plate

7 - Inner plate

8 - Last outer plate

• Thicker than other outer plates.

9 - Retaining ring

• Ring will not be replaced. Therefore, remove and install carefully, not over-stretching it with force.

Disassembling "K4" from above 

• Remove retaining ring for plates.
• Remove plates.

• Slowly and carefully press down spring seat only far enough that the ring can be removed.
• Remove retaining ring.
• Remove spring and spring seat.
• Drive piston out of clutch housing.

• To do this, gently strike a plastic mallet against the upper edge of the clutch housing.

Assembling "K4" clutch housing from above 

• Carefully press piston by hand into clutch housing to stop.
• Lay spring, spring seat and retaining ring in clutch housing.

• Slowly and carefully press down spring seat only far enough that the ring can be installed.
• Install retaining ring.