"K1" Components, Overview
WARNING: This page is about a different variant/trim than selected.
1 - Clutch housing
2 - Piston
- On the piston, there are two O-rings which must not be damaged.
3 - Spring
4 - Piston cap
5 - Retaining ring
- For piston.
6 - Dished spring
- Convex side faces piston cap.
7 - Outer plate
- Figure shows 7 plates. Depending on transmission, fewer may be installed.
8 - Inner plate
- Figure shows 7 plates. Depending on transmission, fewer may be installed.
9 - Last outer plate pressure plate
- Thicker than other outer plates.
10 - Retaining ring
- For plates.
- Ring will not be replaced. Therefore, remove and install carefully, being careful not to over-stretch it.