Torque Settings
WARNING: This page is about a different variant/trim than selected.
Transmission to engine
| Item | Bolt | Qty. | Nm |
| 1 | M 12 x 40 | 1 | 80 |
| 2 | M 12 x 60 | 3 | 80 |
| 3 | M 12 x 70 | 1 | 80 |
| 4 | M 10 x 70 | 1 | 45 |
| 5 | M 10 x 55 | 2 | 45 |
| A + B | Dowel sleeves in engine | ||
Left assembly mounting to bracket - arrows -
- Replace bolts.
50 Nm plus an additional 90 °
Pendulum support
- Replace bolts.
Bolts - A - 20 Nm plus an additional 90 °
Bolts - B - 40 Nm plus an additional 90 °
NOTE:
- Install engine and transmission mountings without tension. Refer to 10 - ENGINE - ASSEMBLY .
Transmission bracket - A - to transmission
- Replace bolts.
Bolts - arrows - 50 Nm
Converter to drive plate: 60 Nm
Retainer for power steering line to transmission. Refer to 48 STEERING .
Power steering line to transmission. Refer to 48 STEERING .
Retainer to valve body cover. Refer to 48 STEERING .
Drive shaft to flange shaft. Refer to 40 FRONT SUSPENSION .
Swivel joint to suspension link. Refer to 40 FRONT SUSPENSION .
Coupling rod to suspension link. Refer to 40 FRONT SUSPENSION .
Wheel bolt to wheel hub. Refer to 40 FRONT SUSPENSION .