Assembly Continuation

• Remove thrust washer again from "K2" and attach in cover with petroleum jelly (e.g. Vaseline).

Fig 1: Installing Spring

Courtesy of VOLKSWAGEN UNITED STATES, INC.

• Install spring - 2  -.

The spring installs in only one position.

• Install Transmission Input Speed (RPM) Sensor G182 - 1  -.

Next, ATF lines must be installed. Do not cant lines during installation and push both ends evenly into transmission housing to stop.

Fig 2: First Install ATF Lines And Then Install ATF Line With Line Clips

Courtesy of VOLKSWAGEN UNITED STATES, INC.

• First install ATF lines - 1  - and - 2  -.
• Then install ATF line - 3  - with line clips - A  -.

Fig 3: Inserting Seal -B- Into Transmission Housing

Courtesy of VOLKSWAGEN UNITED STATES, INC.

• Insert seal - B  - into transmission housing.