Transmission housing and selector mechanism, removing and installing
WARNING: This page is about a different variant/trim than selected.
1 - Countersunk head bolt, 25 Nm
2 - Flange shaft with spring
- Removing and installing. Refer to Flange shaft oil seals, replacing
- Complement. Refer to item 22 in Differential, disassembling and assembling
3 - Torx socket head bolt, 30 Nm
- For reverse shaft support
- Self-locking
- Always replace
4 - O-ring
- Always replace
5 - Pivot pin
6 - Bolt, 25 Nm
7 - Bolt, 25 Nm
8 - Cover plate
9 - Transmission housing
- Servicing. Refer to Transmission housing and clutch housing, servicing
10 - Clutch housing
- Servicing. Refer to Transmission housing and clutch housing, servicing
11 - Hex bolt, 25 Nm then turn 90 ° further
12 - Selector mechanism
- Disassembling and assembling. Refer to Transmission selector mechanism up to 05.99, disassembling and assembling
- From 05.99 a modified selector mechanism has been introduced
- Disassembling and assembling. Refer to Transmission selector mechanism from 05.99, disassembling and assembling
13 - Hex bolt, 25 Nm