Selector mechanism, removing and installing: Installing
WARNING: This page is about a different variant/trim than selected.
Installation is carried out in the reverse sequence. Also, note the following:
- Align gear lever housing parallel to body.
- Distance to body must be same on both sides.
Adjusting selector mechanism. Refer to Gear selector mechanism up to 05.99, adjusting
Tightening torques
| Selector housing to body | 25 Nm | |
| Cross support to body | 25 Nm | |
| Selector cable support bracket to transmission | 25 Nm | |
| Selector cable bolt to transmission selector lever | 25 Nm | |
| Balance weight to transmission selector lever | 25 Nm | |