Lubrication system components
WARNING: This page is about a different variant/trim than selected.
NOTE:
- If large quantities of metal particles or abraded material are detected during engine repairs, it may be an indication for a damaged crankshaft or rod bearings. To prevent further damage, perform the following steps after the repair:
- Carefully clean oil passages
- Replace oil injection jets
- Replace oil cooler
- Replace oil filter
- The oil level must not be above the max. mark - danger of damage to catalytic converter! Marks Markings on oil dipstick under Lubrication system components, assembly overview
Checking oil pressure and oil pressure switch, refer to Oil pressure and oil pressure switch, checking .