Engine and transmission mountings, aligning

WARNING: This page is about a different variant/trim than selected.

CAUTION: Before loosening bolts, secure assembly using engine support bridge 10 - 222 A.

Fig 1: Measuring Engine Mounting

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Engine mounting

a = 14.0 mm

b = minimum 10.0 mm

Both bolt heads - 1 - must be flush with edge c.

Fig 2: Transmission Mount Dimensions

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Transmission assembly mounting

Edges a and b must be parallel to each other.